For Users Upgrading from Design Manager SE6

Top  Previous  Next

An automatic data conversion is only available for users of Design Manager SE6.  The data conversion will automatically initialize when you install Design Manager 2011.  You can, however, choose not to run the conversion at the time of installation, opting to convert at a later time.  Before converting your data make sure that Design Manager 2011 is completely installed, that the Product Code on the back of the CD case has been entered, and that you can successfully open the software.

 

*Be SURE that you have run the suggested Live Update before Converting.

 

Product Code

 

Converting at a later Time:

 

*Upon Converting any data that you may have entered into the Newly Installed 2011 program will be overwritten with your SE6 data*

 

When you are ready to convert your data, insert the Design Manager 2011 installation CD again.  On the main installation window, choose "Convert Data".  If the CD does not start automatically, click on the Start button in the lower left corner of your desktop.  Choose Run, type d:\setup into the Open box, and click OK (in place of “d:” you may substitute the letter of your CD-ROM drive).  Note:  For Vista or Windows 7, you will need to choose Start è All Programs è Accessories è Run.  Read the on-screen instructions carefully before proceeding.

 

Data Conversion